SI-Pro / Air-Byte
Hardware Setup
SI-Pro Male DB-9
BS2 Board Female DB-9
Note: On some BASIC Stamp 2 development boards you need to remove the female DB-9 mounting screws as shown above for a direct connection with the SI-Pro male DB-9 connector.
These are just a few examples. The SI-Pro can be used with any BASIC Stamp 2 development board, including:
 | The BASIC Stamp 2 Super Carrier Board |
| The BS2 Home-Work Board [shown below] |
| The Board of Education & BOE robot [shown below] |
| The INEX-1000 |
| The BASIC Stamp Activity Board |
| The BASIC Stamp 2 OEM Board |
| BS2p Demo Boards |
Photos below show optional accessories, and connection options. Pictures have been reduced to thumbnail size for fast page loading. Click on each picture for a full sized view.
SI-Pro with 6-inch flat-ribbon DB-9 serial cable
connection to BASIC Stamp 2 Home-Work board. This configuration can also use
standard round type DB-9 serial cables.
SI-Pro direct connection to BASIC Stamp
2 Home-Work board with female right-angle 9-V transistor battery adapter.
Use this configuration for maximum portability.
SI-Pro flat-ribbon serial cable connection to
BASIC Stamp 2 BOE robot
with straight 9-volt transistor battery adapter. 9-V battery mounts under
BOE board. Aluminum 0.375" 4-40 HEX standoffs are used to raise the BOE board
for additional storage between board and aluminum robot base.
SI-Pro direct connection to BASIC Stamp 2 BOE
robot with straight 9-volt transistor battery adapter, and 0.375" 4-40 HEX
aluminum standoffs to raise BOE board for additional storage between board
and aluminum robot base.
SI-Pro Power Supply Requirements
Center Positive 2.1mm Jack 9-12 Volts DC 300mA minimum current
capacity.
Will also operate with 9-V transistor battery for mobile applications.
Note: Connect the Air-Byte IR transceiver to the PC serial port before applying power. When connecting the Air-Byte directly to embedded controllers, use inverted serial mode, or hold the TX pin at logic 0 when idle.
Air-Byte with optional 4-foot 9-Pin
flat-ribbon DB-9 serial cable & 9 VDC 500mA power supply
Air-Byte Power Supply Requirements
Center Positive 2.1mm Jack 9-12 Volts DC 500mA minimum current
capacity.
Will also operate with 9-V transistor battery for mobile applications.
6-Inch 9-Pin flat-ribbon DB-9 serial
cable
&
4-Foot 9-Pin flat-ribbon DB-9 serial cable
Flat-ribbon cables work with the Air-Byte & SI-Pro
9 VDC 500mA power supply for
Air-Byte & SI-Pro infrared transceivers.
Female straight 2.1mm ID x 5.5mm OD center + plug
9-Volt battery adapter for SI-Pro or
Air-Byte
Female straight 2.1mm ID x 5.5mm OD center positive + plug
9-Volt battery adapter for SI-Pro or
Air-Byte
Female right-angle 2.1mm ID x 5.5mm OD center + plug
Order SI-Pro & Air-Byte Transceivers & Accessories
Air-Byte IR
Transceiver & Accessories HERE
SI-Pro BASIC Stamp
Programmer & Accessories HERE
The Complete BASIC Stamp Infrared
Programming Package HERE
Click HERE for SI-Pro Software Introductions
Copyright © 1999-2002 Reynolds Electronics
Reynolds Electronics
3101 Eastridge Lane
Canon City, Co. 81212
Voice: (719) 269-3469
Fax: (719) 276-2853